Skip to Content
All American RO Systems Support
RO Filters Installation
1
Remove the first sump from the RO unit
When facing the unit, this would be the far right sump.
Remove the packaging from the sediment filter (red top) and grease the O-rings on the top of the filter. Push the filter into the filter top, ensuring it is fully seated.
2
Tighten the far right sump hand tight and secure it with the supplied filter wrench by turning it an additional 1/4 - 1/2 turn
3
Remove the middle sump from the RO unit
Remove the packaging from the carbon block filter (white top) and grease the O-rings on the top of the filter.
Push the filter into the filter top, ensuring it is fully seated.
4
Tighten the center sump hand tight and secure it with the supplied filter wrench by turning it an additional 1/4 - 1/2 turn
5
Remove the leftmost sump from the RO unit
Remove the packaging from the chlora- mine carbon block (green top) and grease the O-rings on the top of the filter.
Push the filter into the filter top, ensuring it is fully seated.
6