Skip to Content
Matrixx Infusion Support
Chemical Injection Pump Start-up Instructions
1
Plug the chemical pump power cord into a continuously energized 110v outlet
The chemical pump should be set when the unit is shipped. It should be set to "20 SECONDS" and the percentage should be set on 50%.
2
If changes need to be made, the pump must be unlocked
If the pump is locked, push and hold the mode and the percentage "%" buttons at the same time and hold them for 3-5 seconds. The pump locked sentence will disappear. If "STANDBY" is on the screen, push and hold the "MODE" and "STBY" buttons and "STANDBY" will disappear.
3
To change the "mode" to "20 SECONDS", hold the mode button while using the up or down arrows to change the setting
4
To change the percentage, press and hold the "%" button while using the up or down arrows to change the percentage to the desired rate
The pump is now programmed for initial startup. See the "Bubble Method" under Hydrogen Peroxide Injection Rate Adjustment Instructions for pump adjustment.
5
Once the pump is programmed, pour the supplied hydrogen peroxide in the chemical tank
Now push and hold the "PRIME" button as well as the "MODE" button until the pump pulls the solution from the container up to the pump and on to the injector. The level can be seen in the tubing as the pump becomes primed. Once it is primed, the pump is ready to use, The pump will operate during the startup process. If the pump is not working, see below.
NOTE: If the pump is showing "STANDBY", hold the "MODE" button and push the "STBY" button to take the pump out of the standby mode. The display will not show "STANDBY" if it is in normal operation. BE SURE to check that the pump is not in the
"STANDBY" mode. If the pump is left in "STANDBY", it will not operate during regeneration as intended. If the pump is "LOCKED", it will need to be unlocked to make changes.
If the valve is "LOCKED", press and hold the "MODE" and "%" buttons at the same time for 3-5 seconds to unlock.